Plum Audio – Rack Plumber (single unit) 4hp brushed aluminium panel only

£9.99 (exc VAT)

This listing is for a brushed aluminium Rack Plumber panel only.

You need at least 2 Rack Plumbers units for the module to function, but up to 4 can be chained with the expansion pcb

Rack Plumber cable management for large cases

Connect 8 signals with one cable, either inside or outside your case.

In stock

Description

RackPlumber is a simple but useful utility.

It can be used to connect up to 8 signals between 2 points in your case or between different cases by means of standard network cables (RJ45).

Features:

8 jack sockets with led to indicate if there is signal in the jack (the leds are disconnected when jack is plugged in to prevent voltage drop).

Front RJ45 connecter to connect between different cases.

Back RJ45 connecter to connect 2 points inside case.

The module is fully passive (no power supply required) and simply wires the 8 sockets to 8 pins of the network connectors.

Work with shielded or non shielded network cables.

Option to use non shielded network cable (in this case the first channel used to transfer ground and only 7 channels left for signals, must be set with jumper on the back of the module).

Option to use as passive multiplayer when chain together more than 2 modules (with front and back RJ45 simultaneously).

Option to chain up to four modules with RackPlumber MULT board.

See image for jumper settings for shielded/unshielded cables.

Notes:

The module can be used for all kind of signals: control voltages, audio and digital signals (like Clock, Gate, Start, Stop, Reset). If longer RJ45 (> 2 m) cables are used the transmission performance and the cross-talk between signals depend upon the length and the quality/shielding of the used RJ45 cables.

The leds indicate only positive signals.

At least 2 RackPlumber modules are needed to connect to each other.

 

BOM:

8 X Thonkiconn

8 X SMD Leds (1206)

8 X 1.0k-2.5k Resistors (0603) (for leds brightness)

1 X Male pin header 1X3 with jumper (for shielded / non shielded jumper)

1 X Male pin header 1X2 with jumper (for jack leds jumper)

1 X Vertical DIP RJ45 connector (goo.gl/J9uo6H)

1 X Right Angle DIP RJ45 connector (goo.gl/GhxL6N) (can use 2 vertical connectors if you don’t care about skiff friendly)

Additional information

Weight 75 g
Dimensions 128.5 × 20 × 4 mm