This listing is for a full kit with SMD pre soldered. Includes power cable and mounting screws.
Super Parasites firmware is pre installed, all you have to solder are the leds/jacks/pots/switches.
Please note the polarity of the Freeze button that is marked on the pcb!
ROUND LED ORIENTATION : See gallery images
SLIDER LED ORIENTATION
Pull out the leds that are in the sliders, cut the pins on the included two pin leds to the same length and push into the slider.
Send a positive voltage to the appropriate CV control for each slider, if the led lights red pull it out and flip it over.
See product gallery for build instructions
You will have to calibrate the module yourself but it is a simple procedure.
Hold down the Trig button while you power on your case.
send 1V to the v/oct input
press the Trig button
send 3V to the v/oct input
press the Trig button again
Done!
Typhoon is a 16hp expanded version of Mutable Instruments classic Clouds.
Clouds – C-by-SA Émilie Gillet
Typhoon features sliders for the four main controls with bipolar leds to give visual feedback of the cv amount, and four pots with cv inputs for the different effect parameters (wet/dry – stereo width – feedback – reverb amount) that were only accessible with repeated button pushes on the original.
It also features VCAs and mute switches on the input and output (pre reverb) and an additional +6 dB of gain on the output to compensate for low output levels.
The Aux input sends CV to all controls that aren’t currently connected to a jack.
There are now two VU meters, top for input, bottom for output.
Pitch is now controlled by two separate inputs: the V/Oct input is exponential and the Pitch input is linear. When both inputs are used, their voltages are summed.
A manual Trig switch (for capturing individual grains) has been added, in addition to the Trig input that was present on Clouds.
The module includes all the alternate firmwares without the need for re-programming.
Redesign by Jakplugg Open Source
All SMD is factory mounted.